Breakdown maintenance of Road snow blower | snow plow | snowplow
Abstract
Road Snow Blower | Snow Plow | Snowplow Breakdown
Possible causes of failures and troubleshooting methods
The engine won’t start
The oil in the tank is used up Fill the tank with oil
The oil in the fuel tank is an old oil
Drain the old oil outdoors and fill the tank with clean, fresh gasoline
The engine is too cold and the damper is not set to “ON”
Turn the damper to the “ON” position
The spark plug connection line is not connected properly
Connect the spark plug
dirty air filter
clean air filter
Spark plugs are dirty or damaged
Clean spark plugs, and replace damaged spark plugs
Carburetor spilling oil
Turn the damper to “OFF” and start the engine
The engine does not run smoothly The damper knob is in the “ON” position
Turn the damper knob to “OFF”
(chug and chug) The connection of the spark plug is loose
Connect the spark plug correctly and make it tight
use aged oil
Drain old oil outdoors and fill the tank with fresh, clean gasoline
carburetor changes
reset carburetor
The oil hole in the oil filter cap is clogged
Clean oil filter cap, oil hole
dirty air filter
clean air filter
Snow cannot be cleared Protective bolts are damaged
Replace with new protective bolts
Blocked snow plows or blowing hoses
Shut down the engine, disconnect the spark plug wires, and clear the obstruction
Incorrectly adjusted snow plow drive unit hitch cable
Adjust the connection cable
If the V-belt is loose or damaged
The V-belt is loose or damaged Tighten the loose V-belt;
Replace damaged V-belts
The unit will not drive. The connection cable of the drive system is not adjusted correctly.
then adjust the connecting cable
Ice buildup on drive train components
Remove ice from parts
Wear the rubber layer on the friction wheel
Then replace the rubber layer on the friction wheel
Excessive swing Loose parts or damaged snowplow
Immediately shut down the engine, disconnect the spark plug cable, tighten the screws and nuts, and repair the damaged snowblower
Very difficult to switch gears (Type 3 – Type 9)
then adjust the connecting cable
Improperly adjusted coupling cables for the drive system
then adjust the shift lever
Breakdown maintenance of road snow blower | snow plow | snowplow
Written by: JZ POWER
The Exporter and Manufacturer of Snowblower Snowmobile since 2003
Welcome OEM and ODM
#electricscooter #kickscooter #snowblower #snowthrower #tracksnowblower #tracksnowthrower #caterpillarsnowblower #caterpillarsnowthrower #handpushsnowblower #handpushsnowthrower #snowski #snowmobile #snowscooter #snowsweeper #atvsnowblower #atvsnowblower #kidski #kidsskis #kidsski #snowflash #snowdisk #snowdisc #snowkuki #snowsled #electricscooter #scooter #elecrtricscooterfactory #scooterfactory
